Projectiondesign Action one mk III Guide de l'utilisateur télécharger pdf (Page 54)

english

54MIPS User’s Guide – Masking

Note! To add the last line connecting the ﬁ rst and last control point, it is important select

both of the control points required to encapsulate the calibration area (Figure 11-44). To

select multiple points, either press and hold Ctrl while using the mouse point to select

points or drag and drop a selection rectangle over the points. Finally click

(Add) again

to add the last line.

Figure 11-44. Clipping area complete.

Finally, go to online mode to see the results.

Removing clip areas

To remove a masked (clipped) area, select a complete area by performing a drag and drop

selection over a given area. Individual points can also be select by pressing and holding Ctrl

while selecting with mouse pointer.

Click “Remove” in the Calibration Panel Toolbar to remove the area(s) selected. Individual

lines in an area can also be selected and removed.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 67 68

Pas de commentaire

Projectiondesign Action one mk III Guide de l'utilisateur Page 54