Projectiondesign Action one mk III Guide de l'utilisateur télécharger pdf (Page 39)

www.projectiondesign.com

english

Figure 8-26. Adding a blend zone.

The “Add Blend Zone” window in Figure 8-27 will appear. Conﬁ gure the initial parameters for

the blend zone and click “Add Blend Zone” to add it to the UI. “White” means the location

of the full on side of the blend zone (white line). “Black” means the location of the full off side

of the blend zone (black line). These blend zone will be completely disconnected from the

warping and should hence be applied after the geometry correction is complete.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 67 68

Pas de commentaire

Projectiondesign Action one mk III Guide de l'utilisateur Page 39