Projectiondesign F3 XGA-6 Guide de l'utilisateur télécharger pdf (Page 16)

english

LAMP OPERATION

The projector is fitted with two individual projection lamps that can be

run in various modes. In addition, lamps can be replaced as needed

separately. This ensures an optimized cost of ownership. Individual

lamp timers are maintained for each lamp.

Lamp operation mode is controlled in the LAMPS sub menu.

PIN CODE

The projector may be controlled by a PIN (Personal Identity Number)

code. The PIN code is 4 digits, and if the PIN code is activated, you

must issue the right code to unlock the projector.

To activate the PIN code, see the UTILITIES sub menu.

If a wrong PIN code is issued, you may try again two times. If you fail

three times in a row, a PUK (unnlock) code is needed. The PUK code

is supplied with the product.

If you also fail three times with the PUK code, the projector locks up

permanently, and can only be unlocked by a special service unlock

code.

To access this code, you will need to contact your dealer or a service

station. The service unlock code will be generated based on a secure,

encrypted number that is produced by the projector itself. The

projector will produce a new number every time.

english

Downloaded From projector-manual.com Projectiondesign Manuals

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Pas de commentaire

Projectiondesign F3 XGA-6 Guide de l'utilisateur Page 16