Projectiondesign Action two Guide de l'utilisateur télécharger pdf (Page 37)

english

www.projectiondesign.com

6.4 Multi-channel 3D synchronization

X-PORT DCC120 has advanced capabilities for handling synchronization of multiple projec-

tors in a 3D installation.

6.4.1 Synchronous frame sequential

A typical synchronous frame sequential 3D setup is shown in Figure 6-2.

Figure 6-2. Synchronous frame sequential 3D

In this case IGs are synchronized and 3D sync from the source is connected from the DIN

connector on the IG to the BNC sync-in connector. The source 3D sync is then sent to every

projector in the setup. See table below.

SETTING PROJECTOR 1 PROJECTOR 2

3D Frame sequential Frame sequential

3D L/R sync BNC sync-in BNC sync-in

3D BNC sync-out signal Pass through Pass through

6.4.2 Asynchronous frame sequential

This mode is not supported.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 53 54

Pas de commentaire

Projectiondesign Action two Guide de l'utilisateur Page 37