Projectiondesign Action one mk III Guide de l'utilisateur télécharger pdf (Page 13)

english

www.projectiondesign.com

4.4 LED indicators / Front button

The front button and the Power and Status LED-indicators on the processor front panel have

the following functions:

Front button: Power LED: Status LED:

Push 1 time:

Show info on screen

(visual ID/IP/present serial no.)

BLUE: ON GREEN: ON

Push 3 times: Reboot

BLUE: Blinking

•Bootingup

GREEN: Blinking

•DVIINnotvalidand/or

•NetworknotOK

Press and hold

5 seconds:

Network reset

YELLOW: Blinking

•Upgradingsoftware

RED: ON

•Temperaturetoohigh

Press and hold

15 seconds:

Factory reset

Figure 4-3. Front button and LED-indicators

4.5 Network settings

For optimum performance during calibration, a 1.0 Gbps Ethernet connection is

recommended. 100 Mbps will also give adequate performance.

The communication between the control PC and multi image processing system units is

based on a bidirectional XML protocol. We recommend that any ﬁrewall between Control PC

and multi image processing system units should be disabled.

Multi image processing system processors support DHCP in a network environment. Static

IP addresses can be set if there is no DHCP server available. Processors also support Zero

conﬁguration networking (zeroconf).

Note! It is recommended that the multi image processing system processors and the

ProNet Control PC are run in a dedicated network environment.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 61 62

Pas de commentaire

Projectiondesign Action one mk III Guide de l'utilisateur Page 13